I’d love to know if you try this and what you think of it in the comments below, or if you have any questions. We’ve been using this feeder for about a month now and really like it! We don’t have to go in there anymore to pull another layer of hay, and the sheep can eat it all the way down to the last flake. And the bolt will prevent the front and back gates from falling off.Īnd thats it, your diy hay feeder is done! Super quick and easy. Now your front and back gates will be resting onto of the side gates allowing them to move back and forth. Grab your carriage bolts and stick them in the pin holes, adding the washer and nut at the bottom.(The pic below will help me better explain). Make sure to line them up so that the pin holes on the front and back gate panels are resting in between the top bar of the sides gate panels. Get your 4 gate panels and position them into a square.8x nuts and washers to match your carriage bolt.4x gate panels 12’ long (the 12’ long panels fit 2 large round bales, if you dont need that, you can get smaller gates just be sure to measure the type of bale you’re using).And if you have a tractor the bale spears will reach through to easily move. But if the bale is well dispersed when you first put it in they will have no reason to want to go in if they can reach the hay from the outside.Īnother great thing is that it is light enough that with 2 people you can move it a little to position it. Though, some lambs can still fit through – never the ewes. We added cattle panel onto the gate to prevent wasted hay, but they couldn’t fit in as well, so we just left it on the non-mobile sides. This feeder is super great because the sheep can reach all 4 sides, and they can push the front and the back to reach the centre of the bale. I’ll get to the super easy diy hay feeder tutorial in a sec. 39,500 Albers, IL, USA Click to Contact Seller Kuhn VT244T VT 200 Series Vertical Mixer - 440 Cu. We have tons of gate panels lying around!! So we got to work and did a little plan of how we wanted this feeder to work and started building. (2) Hoffman Brothers Welding hay bale feeders Cone inserts Wellsville, KS, USA TEAGLE TOMAHAWK 8500 USED Manufacturer: Teagle Model: Tomahawk 8500 Teagle Tomahawk bale processor. That’s when we realized we need a self-feeding hay feeder that was meant for sheep!! We were going to spend lots of money on a pre-build feeder off Kijiji, but then we looked around at all the raw material we already had at the ranch. It was always our concern that once they were inside the feeder, they wouldn’t be able to get out and would defecate in their the entire night, again wasting the hay. Yes, just when you think the opening is too small, nope. Sheep Can Reach All Sides of BaleĪs mentioned above the sheep couldn’t reach the centre of the bale, therefore we have to constantly climb up and pull a new layer down so they could eat. A lot of hay was getting wasted when were using the cattle feeders for the large round bales because the sheep couldn’t reach all the way to the centre. The last thing you want is half your hay bale getting trampled and wasted.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |